Engineering Drawing 1st Year, Common For All Trade
Sanjay Rathod
0 Comments
ITI Engineering Drawing 1st Year, Common For All Trade
SET -1
1. Which of the following is not a Type of quadrilateral. a) Rectangle b) Square c) Rhomboid / Parallelogram d) Circle
Answer: D
2. In a square how many angles are at right angles. a) 1 b) 2 c) 3 d) 4
Answer: D
3. If an angle which is less than 90° is called an ______ a) Right angle b) Obtuse angle c) Straight angle d) acute angle
Answer: D
4. If an angle which is more than 90° is called an ______. a) Right angle b) Obtuse angle c) Straight angle d) Acute angle.
Answer: B
5. When the sum of the two adjacent angles is equal to 180o, are Called _________. a) Supplementary angles b) Obtuse angle c) Straight angle d) Acute angle.
Answer: A
6. Sum of the three angles in a triangle is (interior angles) equal to ________. a) 180° b) 90° c) 360° d) 120° Answer: A
7. ______ is a triangle having all the three sides equal.
a) Isosceles triangle b) Scalene triangle c) Equilateral triangle d) Right angled triangle Answer: C
8. The side opposite to right angle in Right angled triangle is called ____.
a) Adjacent side b) Hypotenuse c) Opposite side d) Line
Answer: B
9. In a _____ opposite sides are equal and parallel. Opposite angles are also equal. a) Rectangle b) Square c) Parallelogram d) Circle
Answer: C
10. Continuous thin, line are used for _________.
a) Hidden outlines b) Cutting planes c) Center line d) Dimension lines
Answer: D
12. The line given below is used for_______.
a) Long-break line b) Cutting plane c) Censorial lines d) Out lines of adjacent parts
Answer: A
13. The line given below is used for_______.
a) Hidden outlines b) Cutting planes c) Hidden edges d) Dimension lines
Answer: B
14. The line given below is used for_______.
a) Long-break line b) Cutting plane c) Center lines d) Out lines of adjacent parts
Answer: C
15. Which line is used for drawing visible outlines and visible edges
a) Long-break line b) Dashed thick c) Continuous thick line d) Chain thick